[Opm] Surface tension in opm-upscaling

[Lezin Galibert]

Hello everyone,

I have been digging up in the opm upscaling code and I noticed that the
surface tension is defaulted to 1. What unit does this correspond to? I
could not find anywhere in the code a reference to the commonly used
surface tension unit (dynes/cm) so I was assuming that the default unit
would be N/m, but apparently not.

Alternatively, if I were to provde the routine with a value for sigma,
what unit should it be in?

Thank you
Lezin

**********************************************************************************************************
IMPORTANT NOTICE

The information in this e-mail and any files transmitted is the property of PETRICORE and is intended only for the person or entity to which it is addressed and may contain confidential and/or privileged material. Any review, retransmission, dissemination or other use of, or taking of any action in reliance upon, this information by persons or entities other than the intended recipient is prohibited. If you received this in error, please notify the sender immediately and delete the material from any computer.