[Opm] Typical Run-time for SPE10

[Alf Birger Rustad]

Hi Kang,


The short answer is that flow does not support running the model yet. The long answer is that SPE10 Model 2 is a two-phase upscaling study, and hence by nature not fond of the preconditioning routines used by default in flow (or some of the commercial simulators for that matter). The most obvious remedy to this is to exploit the fact that SPE10 Model 2 is a two-phase case, and to use algebraic multigrid based preconditioning. We just very recently landed a true two-phase simulator version of flow, which actually supports an AMG based linear solver. Adapting the deck to this reality may finally make SPE10 Model 2 run well with flow.


Cheers,

Alf

________________________________
Fra: Opm <opm-bounces at opm-project.org> på vegne av Kangqiao Hu <kangqiaohu at gmail.com>
Sendt: 14. august 2017 05:13
Til: Opm at opm-project.org
Emne: [Opm] Typical Run-time for SPE10

Hi everyone,

I am running spe10 model2 using flow with single thread on a Intel i7-7820hk mobile processor, and the simulation has been running for more than 4 days and it seems to be far from complete. I was wondering what is the typical time of running this test case? Thanks!

Regards
Kang


-------------------------------------------------------------------
The information contained in this message may be CONFIDENTIAL and is
intended for the addressee only. Any unauthorized use, dissemination of the
information or copying of this message is prohibited. If you are not the
addressee, please notify the sender immediately by return e-mail and delete
this message.
Thank you
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <//opm-project.org/pipermail/opm/attachments/20170814/75b68519/attachment.html>